Erm, well I fitted the brand new ones that came in the bag. They where oiled too so no obvious signs of drying out, cracking or other failure.
TBH they look like they are just cut off a length of pipe, so i suspect if you find the right ID/OD rubber hose and cut a piece off, finding replacement seals shouldn't be that hard.
That earthing block is magic, it even earths the telephone line in my house!
-
- Site Admin
- Posts: 7512
- Joined: 10 Oct 2006
- Location: BXProjectHQ
- mat_the_cat
- Centenial time waster
- Posts: 2656
- Joined: 01 Apr 2009
Re: Heater Tap Replacement
It doesn't earth pin 3 on the heater control PCB though, despite the Haynes BOL saying it does!
Bit like the LHM pipe seals then, they are blatently just cut from a length of hose.
Bit like the LHM pipe seals then, they are blatently just cut from a length of hose.
-
- Site Admin
- Posts: 7512
- Joined: 10 Oct 2006
- Location: BXProjectHQ
Re: Heater Tap Replacement
I guess once the children with the 7" fingers had finished putting exhaust manifolds onto cars, they had to do something. Clearly this was cutting up pipe for seals.
- docchevron132
- Bus Warrior
- Posts: 11929
- Joined: 10 Oct 2006
- Location: Sat with a hammer under 8666KGs of rust!
- Contact:
Re: Heater Tap Replacement
7" fingers, and 30 of them each..
1989 BX 17TD P2 Hybrid
1990 BX 16V It's got big hairy bollocks
1971 BL 350FG ambulance
1993 Dennis Lance 132 It's got mahooosive hairy bollocks!
Euthenasia, because enough's enough already.
1990 BX 16V It's got big hairy bollocks
1971 BL 350FG ambulance
1993 Dennis Lance 132 It's got mahooosive hairy bollocks!
Euthenasia, because enough's enough already.