Trolley Jack as Hydraulic Press...?
Posted: 29 Feb 2008
About a year ago, i replaced the bottom engine mount (the one that's pressed into the housing that the drive shaft passes thro')
I pushed it in using my vice and a 2.5ft scaffold pole The vise suffered a bit and I think if I do it again, it'l spit it's dummy out...
So, I thought if I made summut up to fit my trolley jack, it could be used as a hydraulic press....question is....what forces did I achieve between the jaws of my vice and would a 1.5 tonne trolley jack be enough to push in that big lower engine mount....?
I pushed it in using my vice and a 2.5ft scaffold pole The vise suffered a bit and I think if I do it again, it'l spit it's dummy out...
So, I thought if I made summut up to fit my trolley jack, it could be used as a hydraulic press....question is....what forces did I achieve between the jaws of my vice and would a 1.5 tonne trolley jack be enough to push in that big lower engine mount....?